OPTICS · SEMICONDUCTORS · AI INFRASTRUCTURE | stt@simpletechtrend.com
1.6T OSFP Transceiver 3D Exploded View
Schematic illustration · Updated 21 November 2026
The pluggable optical transceiver is the most common optical component in an AI data center. A 1.6T OSFP takes eight 200G PAM4 electrical lanes from the switch or NIC and sends and receives eight 200G lanes over single-mode fiber. Inside, a DSP conditions the signals, and the optics are built as two identical 4-lane groups: each has its own CW laser, silicon photonic modulator chip, discrete photodiode array and TIA, and its own MPO-12 port at the front (2×DR4).
This interactive 3D exploded view draws the shell to OSFP MSA outline dimensions and uses a typical silicon-photonics 2×DR4 layout inside. Rotate it, explode it, X-ray the housing, click any part for an explanation, and export a branded PNG. The internal layout is a schematic and differs between vendors.
-
Integrated heat sink & thermal pads: the OSFP top is itself a finned heat sink; pads carry heat from the DSP and optics
-
8×200G PAM4 DSP: retimes all eight lanes in both directions and is the biggest power consumer; LPO removes it, LRO keeps it only on transmit
-
CW laser CoS → collimating lens → optical isolator → focusing lens: the laser sits on the fiber side and couples into the silicon photonic chip
-
Silicon photonics Tx PIC & driver: four MZM modulators per group, with the driver wire-bonded right behind the chip
-
Discrete PD array & TIA: receive is not integrated on the PIC; a 45° fiber array turns the light down onto the photodiodes
-
Fiber arrays & dual MPO-12: four transmit and four receive fibers per group, so one 1.6T port can break out to two 800G DR4 links
-
MCU, power, 60-pad card edge, pull tab & latch: CMIS management, supply rails and front-panel hot-swap serviceability
Further reading: Silicon Photonics Transceivers Explained: Six Interfaces, Core Components and Real Industry Examples